Blog

· By Thesisroom

Thesis Page Numbering: Roman Numerals, Arabic Numerals and the Word Steps

How thesis page numbering works: what 13 institutions require for Roman and Arabic numerals and the title page, how to match your rule to one of three patterns, and the Word steps.

This guide has a printable version: open the printable thesis page numbering plan

An open book seen from the spine side, its cream pages fanned out toward the center fold.
Photo by areej fateyma on Unsplash

Thesis page numbering follows your university’s rule, and the rules differ. A common rule asks for lowercase Roman numerals (i, ii, iii) on the front matter and Arabic numerals (1, 2, 3) from the first chapter. The title page is counted but not shown, as at UNC Chapel Hill and NC State. It is not the only one: the University of Manchester requires a single sequence of Arabic numerals and does not allow Roman numerals.

This guide puts 13 institutions’ own rules side by side, shows how to tell which pattern yours follows, and gives the Word steps that produce each one.

What do universities say about thesis page numbers?

They disagree on three points: whether Roman numerals are used at all, whether the title page counts, and which page shows the first number. The table gives each university’s front matter rule, where Arabic numbering starts and what happens to the title page.

UniversityFront matterArabic numbering startsTitle page
UNC Chapel HillLowercase RomanChapter one or the introduction, showing 1Counts as page i, number not shown
NC StateLowercase Roman, starting with ii after the title pageFirst page of Chapter 1 or the main textCounted as the first page, number not shown
NewcastleLowercase Roman for preliminary pagesThe Introduction, counting every pageNot stated
ManchesterNone: Roman numerals must not be usedOne sequence of Arabic numerals from the title pageCounted as page 1, number not displayed
Glasgow (guidance)None: Arabic numerals throughoutFrom the startCounted, not numbered
SalfordSmall Roman, with i on the first page after the title pageThe main document, including references and appendicesNo number, in its own section
Southern Queensland (standard thesis)Roman, starting at i on the abstractThe first chapter, starting at 1No number, outside the Roman sequence
James CookRoman for the introductory sectionsThe start of the body of the thesisNormal not to number it
Otago (library handout, dated 2014)Lowercase Roman for the preliminariesThe text and the reference matterCounted, number not shown
Stellenbosch (convention)Usually RomanNormally from Chapter 1Not stated
IIT Kanpur (updated 2019)Lowercase Roman before Chapter 1The first page of text, through the appendicesConsidered page i, number not printed
Universiti MalayaRoman, with ii on the declaration formStarting with the IntroductionUnnumbered page i
Universiti Putra MalaysiaLowercase Roman before Chapter 1Page 1 is the first page of the Introduction, but it is not numberedCounted as i, not numbered

Some of these documents are guidance, not regulation. Glasgow says its guidelines will not become a regulatory document, Stellenbosch says its examples are not compulsory, and James Cook says its library template is not mandatory. Treat the table as examples of the patterns and read your own university’s current page before you format.

Which pattern does your thesis follow?

Three patterns show up in the table. Find the rule in your handbook or template, match it to one of the patterns, then write it down before you open Word.

  1. Roman front matter, Arabic from Chapter 1, title page counted. The title page is page i with no number shown, and the first number you see is ii. UNC Chapel Hill, NC State, IIT Kanpur and Universiti Malaya work this way.
  2. Roman front matter, Arabic from Chapter 1, title page outside the sequence. The title page carries no number and the Roman count starts after it. Salford starts at i on the first page after the title page, and Southern Queensland starts at i on the abstract.
  3. One Arabic sequence. There are no Roman numerals. The title page is page 1 with the number hidden. Manchester requires this, and Glasgow’s guidance asks for Arabic numerals throughout.

If your handbook is silent, ask your graduate office or supervisor before you format. The thesis structure check shows what to look for in the rules for the order of the front matter pages.

How do you set up page numbers in Word?

Put the title page, the front matter and the main text in three separate sections, unlink their footers, then format the numbers in each section. The steps below follow the Word guides from Salford (Windows), Aberdeen (no platform stated) and the University of Iowa (Mac). Menu names differ a little between Word versions.

  1. Show the section breaks. Turn on Show All in the Paragraph group of the Home tab so you can see the breaks. Salford also suggests right-clicking the status bar and ticking Section.
  2. Give the title page its own section. Click at the end of the title page text, then choose Layout, Breaks, Next Page. On a Mac, Iowa’s guide uses Insert, Break, Section Break (Next Page), and the University of Utah lists Layout, Breaks, Next Page as well.
  3. Separate the front matter from Chapter 1. Click at the end of the last front matter page, such as the contents page, and insert another Next Page section break. The document now has three sections.
  4. Unlink the footers. Open the footer of section 2 (Insert, Footer, Edit Footer, or double-click the bottom margin). It says “Same as Previous”. Click Link to Previous to turn that off, then repeat in section 3. Iowa’s guide says the sections must be unlinked.
  5. Number the front matter. In section 2 choose Insert, Page Number, Bottom of Page, Plain Number 2. Then choose Page Number, Format Page Numbers, set the number format to i, ii, iii, and set Start at to i. If your rule starts the visible Roman numbers at ii, set Start at to ii instead. Iowa’s guide does this.
  6. Number the main text. In section 3 unlink the footer, choose Format Page Numbers, pick the Arabic format and set Start at to 1.
  7. Leave the title page alone. Make no change in the section 1 footer, so it stays blank.
  8. Check the first Arabic page. Aberdeen notes that Word treats a new section as a continuation of the one before unless you change Start at. Scroll to Chapter 1 and confirm it shows 1.

For the one-sequence pattern, skip the Roman numbering and number the whole document in Arabic from page 1. One way to hide the number on the title page, our suggestion rather than a university’s, is the Different First Page option in the Header and Footer settings.

What goes wrong with Word page numbers?

The usual causes are a missing or deleted section break, or a footer that is still linked to the section before it. Three sources name specific failures.

  • A number shows on the title page. Iowa says this may mean a section break in your preliminary pages has been compromised. Check that the title page is its own section.
  • Everything changed after you deleted a break. Salford warns that deleting a section break undoes your page formatting and affects the numbering. Undo the delete, or insert a new Next Page break in the same place.
  • The numbers continue across sections. Without a Start at value, Word carries the count on, which Aberdeen shows with a section that starts at page 4 instead of 1.

What about the contents page, lists and appendices?

Follow your rule for each part, because universities place them differently. The contents page and the lists of tables and figures count as front matter in several rules, and the references and appendices usually continue the main sequence.

Front matter pages each have their own rules too. See our guides to the thesis acknowledgements page, the list of abbreviations and the thesis abstract, and run the page order past the thesis submission checklist before you submit.

Printable thesis page numbering plan

Fill in your university’s rule for each part, then use it to set up the sections in Word.

Part of the thesisNumber style (none, i, 1)Starts atShown on the first page?
Title page
Front matter (abstract, acknowledgements, contents, lists)
Main text (Chapter 1 to the last chapter)
References
Appendices
  • I found the rule in my handbook, graduate school guide or template
  • I know whether the title page counts and whether its number is shown
  • I know where the Arabic numbers start
  • I scrolled through the final file and checked the first page of every section

Frequently asked questions

Does the title page get a page number?It depends on the rule. UNC Chapel Hill counts it as page i without showing the number, Salford and Southern Queensland leave it outside the Roman sequence, and Manchester counts it as page 1 and hides the number.
Should page numbers be at the top or the bottom?Rules differ. UNC Chapel Hill and Newcastle put numbers at the bottom center, IIT Kanpur uses the upper right corner, and Glasgow prefers the top outer corner while allowing the footer. Use the position in your handbook.
Which page shows the first number in the front matter?It varies. At Salford the first page after the title page shows i, at Southern Queensland the abstract shows i, and at NC State and UNC Chapel Hill the first visible number is ii.
Does the first page of Chapter 1 show its number?Check your rule. UNC Chapel Hill shows 1 on the first page of chapter one, while Universiti Putra Malaysia treats that page as page 1 but does not print the number.
Why does my numbering restart or jump in Word?Usually a section break was deleted, a footer is still linked to the previous section, or Start at is not set. Aberdeen, Salford and Iowa each describe one of these causes.

Sources

How this guide was made: Thesisroom drafted this guide with the help of AI writing tools. Every fact, figure and source in this post was checked against its original source before publishing.